![]() ![]() ![]() I used some code out of the propeller obex called jm_servo8.spin and I have modified it to and renamed it PPM Servo Driver PPM Servo and each line I have modified I add ''Dan to the end of the line. 3ms pause between servo pulses according to the PPM protocol. This project allows the long range sending of Servo signals that can be feed directly to a servo or speed controller or read buy and on board Basic Stamp SX or propeller. The modules can be had in many frequency the 72mHz FM ones like I am using need and antenna but the 2.4gHz modules have the antenna built in but are a little more expensive. The Futaba FP-TP-FM module plugs in the back of some of the higher end Futaba radios and allows different frequency and channels to be uses without and entirely new Radio. The modules used are the Futaba FP-TP-FM transmitter and the Futaba FP-R127DF 7 Channel receiver. I Have used a Basic Stamp 2 to send signals out of the TX and I am now working on the Propeller version. I am going to share what I have so far and hope anyone that has question or suggestions will post them. I have been working on a project that uses the plug in TX modules from Futaba RC transmitter radios to send to a Futaba RX receiver. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |